AEG 7000 Series User Manual page 23

Problem
Incorrect programme selection.
The filter is clogged.
Dryness Level option was set to
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
It is not possible After a cycle starts it is not possi‐
to change the ble to change the programme or
programme or option.
option.
It is not possible The option you tried to select is not
to select an op‐ available for the selected pro‐
tion. An acoustic gramme.
signal is emit‐
ted.
Unexpected du‐ The drying duration is calculated
ration time ap‐ according to load size and damp‐
pears on the ness.
display.
The water container is full.
A programme is
inactive.
Possible cause
3)
iron dry .
Remedy
Select a suitable programme.
2)
Clean the filter.
Change Dryness Level option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or option
as required.
Turn the tumble dryer off and on.
Change the programme or option
as required.
This is automated - the appliance
is working correctly.
Drain the water container, push the
2)
Start/Pause button.
ENGLISH 23
1)
4)
2)