Front Control Lever Lock; Armrest Adjust Handle - Hitachi ZW180 Operator's Manual

FRONT CONTROL LEVER LOCK

WARNING: When locking the front control lever, se-
curely push front control lever lock (1) to the LOCK
position (3). Unless front control lever lock (1) is fully
moved to the LOCK position, the front control lever is
not locked, possibly creating a hazardous situation.
Before leaving the operator's seat, be sure to stop the
engine. Then, move front control lever lock (1) to the
LOCK position (3).
After completing operation of the machine or trans-
porting the machine, be sure to move front control
lever lock (1) to the LOCK position (3).
Refer to section 5-4 for details.
Front control lever lock (1) is provided to prevent the machine
is unexpectedly operated even if the operator mistakenly
comes in contact with the bucket and/or lift arm control lever
when getting on or off the machine. When the lever lock is
placed to position (2), the front control lever becomes oper-
able.

ARMREST ADJUST HANDLE

The armrest is used to support the operator's arm so that the
arm force can be controlled when operating the loader control
lever. Turn the handle counterclockwise to lose the armrest
position. After setting the armrest to the desired position, turn
the handle clockwise to hold the armrest in that position.
5- Lose
6- Tighten
OPERATOR'S STATION
1-51
2
UNLOCK
1
4
5 6 5
4
3
LOCK
M4GB-01-050
M4GB-01-076
6
M4GB-01-077