Sealey FWB1.V3 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
Maintain the workbench in good condition. Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be
9
dangerous and will invalidate the warranty.
Keep the workbench clean for best and safest performance and check moving parts alignment regularly.
9
Locate the workbench in a suitable working area. Keep area clean and tidy and ensure there is adequate lighting.
9
Ensure the workpiece is correctly held or secured before commencing work.
9
Ensure that any workpiece which extends beyond the bench is adequately supported.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9
DO NOT use the workbench for any purpose other than that for which it is designed.
8
DO NOT get the workbench wet or use in wet weather conditions, and DO NOT expose the workbench to excessive heat.
8
DO NOT operate the workbench if any parts are missing as this may cause failure and/or personal injury.
8
DO NOT stand on the top of workbench, or use it as standing platform or to support a platform. The workbench is for clamping items
8
only.
When not in use store in a safe, dry, child proof area and ensure it will not topple over.
9
2. INTRODUCTION
Hard-wearing MDF top with pre-drilled jaw grip anchorages. Features vice capability for gripping work whilst sawing, planing and drilling. Bench
legs fold flat for easy storage and incorporate tool storage slots. Suitable for sawing, drilling, planing and sanding operations.
3. SPECIFICATION
Model no .................................................................FWB1.V3
Clamp capacity .......................................................... 235mm
Folded (W x D x H) ..................................605 x 140 x 895mm
Unfolded (W x D x H) ..............................605 x 630 x 750mm
4. CONTENTS
No. Description Qty. No.
1 Worktops 2 8
2 Slide bases 2 9
3 Hex bolts 4 10
4 Crossbars 2 11
5 Leg frames 2 12
6 Plastic feet 4 13
7 Washers 8
Ø16 x
Ø8x1.2
© Jack Sealey Limited
FOLDING WORKBENCH - 235MM CAPACITY
FWB1.V3
MODEL NO:
Description Qty.
Wood screws 16
4.8x1.6mm
Screws 8
(domehead)
M6x1.0x3.7mm
Nuts M6x1mm 8
Nuts M6x1.2mm 4
Chocks 4
Washers 8
Ø13x6x1.2
Original Language Version FWB1.V3 Issue:2 (H,F) 15/07/20