Sealey VS790 Installation Tool Information

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Wear eye
Refer to
Protection
Instructions
1. safety
WarninG! Wear approved eye protection. Wear appropriate Personal Protective equipment. A full range of Personal Protective
‰
equipment is available from your Sealey stockist.
WarninG! ensure that Health & Safety, local Authority Regulations and general workshop practice Regulations are adhered to when
‰
using tools.
do not use tools if damaged.
8
maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
9
ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
9
do not attempt to start or move a vehicle whilst in gear and with timing devices fitted.
8
Wear suitable clothing to avoid snagging. do not wear jewellery. Tie back long hair.
9
Account for all tools, parts and components being used. do not leave these in or near the engine. Return tools to suitable storage
9
after use.
When not in use, store in a safe, dry childproof place.
9
Keep children and unauthorised persons away from the work area.
9
▲ iMPortant! these instructions are intended as a guide only. always refer to the vehicle manufacturer's service instructions
or a proprietary manual to establish the correct procedure and data.
WarninG! The warnings, conditions and instructions in this manual cannot cover all possible conditions and situations. The Operator/
‰
User must apply caution and common sense (good practical sense).
2. introduction
Stretch belt fitting kit for Ford and Volvo. Designed for use where universal tools won't work due to the wider crankshaft pulley which restricts
access. Time saving tool, simple to use, one part of the kit clips over the crankshaft pulley to guide the belt, the other part fits over the water
pump pulley and with a 17mm socket it's simply rotated until the belt is in located correctly on all the pulleys. Suitable for Ford 1.4, 1.6 (Focus,
C-Max, Mondeo) and Volvo 1.6 (S40, C30, V50) petrol engines.
3. contents
© Jack Sealey limited
stretch belt installation tool -
ford/volvo
model no:
Wear Protective
Clothing
item no.
1
2
Original Language Version
vs790
Part no. description
VS790.01 Installation tool
VS790.02 Guide tool
VS790 Issue:1 02/05/19