Panel Front (Grill) Block - Sony CMT-BT60 Service Manual

CMT-BT60/BT60B/BT80W/BT80WB
Note: Follow the disassembly procedure in the numerical order given.
2-2.

PANEL FRONT (GRILL) BLOCK

Note 3: It is not necessary to remove
these two screws.
4 six screws
(BTTP M2.6)
Note 4: When installing the flexible
flat cable, ensure the colored
line.
No slanting after insertion.
OK
Insert is straight to the interior.
flexible flat
cable
colored line
connector
NG
Insert is incline
flexible flat
cable
colored line
connector
5 Remove the panel front (grill) block
in the direction of an arrow.
panel front (grill)
panel rear
Note 5: When installing the panel
front (grill) block, align the
boss of panel front (grill)
with the ditch of the panel
rear.
10
1 Insert a thin pin etc. below the
2 cap rear
3 screw
(BVTP3 10)
6 six claws
9 tape
(sub material)
F e ib e at ab e ettin
cap rear and remove to pull
and raise the cap rear.
Note 2: Take care not to scratch.
cap rear
2 cap rear
3 screw
(BVTP3
7 cushion
(K)
6 three claws
8 flexible flat cable (7P)
0 flexible flat cable (8P)
tape
(sub material)
guide line
a rear ettin
OK NG NG
Distorted. Wrong
location.
10)
Note 1: Please spread a sheet under
a unit not to injure grill side.
– Rear bottom view –
qa panel front (grill) block
6 three claws
6 three claws
(CN3501)
– Front bottom view –