Chassis (Main) Block-2 - Sony HCD-SBT100 Service Manual

2-13. CHASSIS (MAIN) BLOCK-2

Note 1: Before disconnecting flexible flat cable (24P) (CN501), solder the short-land.
8 Solder the short-land.
Note 2: When assembling the
chassis (main) block,
remove the solder of
short-land after connecting
flexible flat cable (24P)
(CN501).
OK
Solder is removed cleanly.
NG
Solder is not removed.
HCD-SBT100/SBT100B/SBT300W/SBT300WB
(SBT300W/
SBT300WB)
2 screw
3 coating
(BV3)
clip
9 flexible flat cable (24P)
2 screw
(BV3)
2 two screw
(BV3)
4 Remove the
chassis (main) block
in the direction
of an arrow.
1 Draw out
wires.
– Rear view
Note 3: When installing the flexible flat cable,
(CN501)
2 two screws
(BV3)
7 chuck cap
6 claw
5 Remove the chuck cap
in the direction
–
of an arrow.
ensure the colored line.
No slanting after insertion.
OK
Inserting is straight to the interior.
flexible flat cable
colored line
connector
NG
Inserting is slant.
flexible flat cable
colored line
connector
2 screw
(BV3)
3 coating clip
0 chassis (main) block
Note 4: When installing
the chuck cap,
align the triangle
6 claw
marks.
OK
6 claw
NG
17