Scpi Command Summary - HP 33120A User Manual

Chapter 2 Remote Interface Operation

SCPI Command Summary

SCPI Command Summary

This section summarizes the (Standard Commands for
SCPI
Programmable Instruments) commands available to program the
2
Phase-Lock assembly over the remote interface. If you are a first-time
user of the language, refer to "An Introduction to the
SCPI SCPI
Language," starting on page 211 in the HP 33120A User's Guide.
Throughout this manual, the following conventions are used for
command syntax.
SCPI
• Square brackets ( [ ] ) indicate optional keywords or parameters.
• Braces ( { } ) enclose parameters within a command string.
• Triangle brackets ( < > ) indicate that you must substitute a value
for the enclosed parameter.
• A vertical bar ( | ) separates multiple parameter choices.
Phase-Lock Commands (Option 001)
(see page 18 and 19 for more information)
radians
PHASe:ADJust {< >|MINimum|MAXimum}
PHASe:ADJust?
PHASe:REFerence
PHASe:UNLock:ERRor:STATe {OFF|ON}
PHASe:UNLock:ERRor:STATe?
OUTPut:TRIGger:IMMediate
OUTPut:TRIGger:STATe {OFF|ON}
OUTPut:TRIGger:STATe?
*OPT?
17