After Operation
After Operation Safety
General Safety
•
Before you leave the operating position, do the
following:
– Park the machine on a level surface.
– Shift the transmission to the N
– Engage the parking brake.
– Lower the cargo bed.
– Shut off the machine and remove the key.
– Wait for all movement to stop
•
Allow the machine to cool before adjusting,
servicing, cleaning, or storing it.
•
Do not store the machine where there is an open
flame, spark, or pilot light, such as on a water
heater or other appliance.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Maintain and clean the seat belt(s) as necessary.
•
Replace all worn, damaged, or missing decals.
Hauling the Machine
•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
Refer to
Figure 19
and
locations on the machine.
Note:
Load the machine on the trailer with the front
of the machine facing forward. If that is not possible,
secure the machine hood to the frame with a strap,
or remove the hood and transport and secure it
separately or the hood may blow off during transport.
CAUTION
Loose seats may fall off the machine and
trailer when transporting the machine, and
the seats may land on another machine or
obstruct the roadway.
Remove the seats or ensure that the seats are
secured by the pivot pins.
position.
EUTRAL
Figure 20
for the tie-down
1. Towing tongue and tie-down point (front of the machine)
1. Rear tie-down points
22
Figure 19
Figure 20
g236535
g034273