Page 3
Siemens Laser Analytics AB can supply a suitable light source labelled HL 3000. This is a point source using a 50 W halogen lamp and will produce a very luminous light spot -...
Page 4
- check that the lens is clean on the receiver and that the purging is working. Halogen alignement lamp Receiver side HL 3000 generates a considerable amount of heat. Protective gloves should be ised Note! when it is handled.
Page 5
LDS 3000 HL 3002 Operators manual Transmitter side 2. Dismount the transmitter and check that the lens is clean on the transmitter and that the purging is working. Then mount the trans- mitter and twist-dismount the launcher (fiber cable connector in the middle), twist-mount the cross hair instead.
Page 6
LDS 3000 HL 3002 Operators manual Transmitter side 3. Twist-mount the alignement lamp instead of the cross hair in the transmitter. Alignement lamp Transmitter side...
Page 7
LDS 3000 HL 3002 Operators manual Receiver side 4. Mount the receiver back again and twist-mount the cross hair instead of the detector module. Align with the four bolts on the flange, the light dot must be centred in the inner ring of the cross hair.