Dis-
Selection
play
Automatic timer
- Switched off.
-
- Cooking time after which the hotplates
switch off.
Duration of the timer end signal
– 10 seconds.
– 30 seconds.
– 1 minute.
Activation of the heating elements
– Switched off
– Switched on
– The last setting before switching off the
1
hotplate.
Time for selecting hotplates
– Unlimited: The last hotplate selected can
always be adjusted without having to select it
1
again.
– You can adjust the last hotplate selected
within 10 seconds after selecting it. After this
time you have to select the hotplate again be-
fore adjusting it.
Resetting to the factory settings
– Switched off.
– Switched on.
Factory setting
1
9.2 Changing basic settings
Requirement: The hob is switched off.
Switch on the hob.
1.
10 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
10.1 Information on display panel
Fault
None
All displays flash
1
1
1
Cause and troubleshooting
There has been a power cut.
Check the household fuse for the appliance.
1.
Check whether there has been a power failure by trying other electrical appli-
2.
ances.
Controls are wet or objects are lying on top.
Dry the controls or remove the object.
▶
Within the next 10 seconds press and hold
2.
approx. 4 seconds.
and
flash alternately on the left-hand display.
a
lights up on the right-hand display.
a
Touch
repeatedly until the required indicator ap-
3.
pears on the left-hand display.
Use
or
to set the required value.
4.
Press and hold
for 4 seconds.
5.
a The setting is activated.
Tip: To exit the basic settings, switch off the hob using
. Switch the hob on again and reset.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
Troubleshooting en
for
11