NEC E328 User Manual page 79

Setup
VGA Options
VGA Mode
Auto Adjust
H.Position
V.Position
Clock
Phase
H.Resolution
V.Resolution
Reset VGA Options
Other settings
Input Labels
Key Lock Settings
IR Lock Settings
Power supply
LED Indicator
Mute Settings
Thermal Management
Signal Information
Monitor Information
Factory Reset
Enabled when a VGA signal is input.
Select [RGB] or [YPbPr] depending on the signal received into the VGA input terminal.
Automatically adjusts settings such as the image position.
Adjusts the horizontal position of the screen.
Press the u button to move the screen to the right or the t button to move it to the left.
Adjusts the vertical position of the screen.
Press the u button to move the screen to the top or the t button to move it to the bottom.
Adjust this setting when vertical lines appear on the screen or when the size differs at the right
and left of the screen.
Adjust this setting when noise appears in the horizontal direction, when the characters are
blurred, or when the contours are not sharp.
The video can be enlarged/reduced in the horizontal direction using this function only when
[Standard] is selected in [Aspect Ratio].
NOTEN
This function may not operate depending on the input signal.


The video can be enlarged/reduced in the vertical direction using this function only when
[Standard] is selected in [Aspect Ratio].
NOTEN
This function may not operate depending on the input signal.


Resets the VGA Options settings to their default values.
Renames the input terminal currently being displayed. Letters (A-Z), numbers (0-9), and some
symbols can be used.
Prevents the monitor from being controlled using the buttons on the monitor control panel.
OffN All buttons operate normally.
Mode 1N Only the power button and the input switching function operate.
Mode 2N All buttons are locked. (Only the power button can be used during standby mode.)
Prevents the monitor from being controlled using the remote control.
OffN All buttons operate normally.
Mode 1N Only the POWER and the SOURCE buttons operate.
Mode 2N All buttons are locked. (Only the power button can be used during standby mode.)
You can configure the power supply to the USB Type-C port.
The power consumption increases when set to [On].
NOTEN
When the Power supply function is enabled, if a signal is input into a terminal


used just before, the monitor enters into On Mode even if it was turned off using
the power button on the remote control or the main unit.
Set it to Off to turn off the power indicator when the monitor is turned on (normally lit blue).
You can change the effect of the MUTE button of the remote control.
AudioN Mutes only the audio files.
VideoN Mutes only the video files.
Audio & VideoN Mutes the audio and the video files.
The monitor is equipped with thermal sensors and displays a warning when the ambient
temperature exceeds the operation guaranteed temperature. If a warning is displayed, turn the
monitor off since using the monitor in such environment may cause a malfunction.
Warning MessageN A temperature warning is displayed on the screen when the internal
temperature has exceeded the operation guaranteed temperature.
ShutdownN The monitor turns off automatically when the internal temperature has
exceeded the operation guaranteed temperature.
Displays the information regarding the input signal.
Displays the information regarding the monitor.
All settings except network are returned to factory default.
English - 76