Preparation of the remote control
Insert the specifi ed battery to the remote control. See
page 8 ,
9
for safety use of coin-shaped batteries.
Gently insert a fi ngernail in groove 1
1
and pull out the holder in direction 2.
Backside
1
Take care not to break your fi ngernail.
2
Place a coin-shaped
battery (CR2025) with the
side up on the holder.
Keep the holder horizontal so that
the battery does not fall through.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.
3
Insert the holder into the remote control.
The remote control battery contains Perchlorate
Material - special handling may apply. See
www.dtsc.ca.gov/ hazardouswaste/perchlorate
26
01_SD-P101SKN_ENG_01-54.indd 26
01_SD-P101SKN_ENG_01-54.indd 26
Operating with the remote control
Point the remote control at the remote sensor and press
the buttons.
2
Distance: About 3 m (9.9 feet) from the front of the remote
Angle:
Do not expose the remote sensor of the player to a strong light
source such as direct sunlight or other illumination. If you do
so, you may not be able to operate the player via the remote
control.
•
Aim the remote control at the remote sensor of the player.
•
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
•
Do not spill water or put anything wet on the remote control.
•
Do not disassemble the remote control.
•
•
If the remote control does not function correctly or if the operating
range becomes reduced, replace the battery with new one.
•
Inserting a battery other than the specifi ed one or an object may
damage the remote control.
Within about 3 m (9.9 feet)
sensor
About 30° in each direction of the front of the
remote sensor
2008/03/07 19:54:36
2008/03/07 19:54:36