Extended Configuration; Hardware; General Data; Installation, Handling And Storage - Bosch IVAS Operating Instructions Manual

5.1.4 Extended configuration

The interpretation of the extended configuration string may be subject to change with the firmware version.
FIRMWARE VERSION
V0.1.1.x
V0.1.0.x
Table 7: Firmware versions

5.2 Hardware

5.2.1 General data

WHAT
Input Voltage
Power available at PD
Typical current consumption
Table 8: Typical values – hardware
*average value (might differ depending on software routine)

6 Installation, handling and storage

6.1 Fixation

Fixation of the module is to be made using a M6 screw with 9±1 Nm. Other fixation methods could damage the sensor
module or influence the results of the measurement by preventing the vibration to be transferred correctly.
The fixation of the IVAS module should be made in a way that both marked sides are always visible, in order to ensure the
correct measurement of vibration.
Axis system in housing is defined based on the X-axis of the High-Bandwidth Sensor.
The axis system of the High-Sensitivity Sensor is prepared currently with the X-axis from IVAS matching the Y-axis from the
sensor, and the Y-axis from IVAS matching the X-axis from the sensor.
HINT: X & Y axis of High-Sensitivity Sensor must be manually changed in the GW. Low g sensor range: +/- 2g (with prototype
fw), possible range up to +/- 16g
DEFAULT (IVAS HOUSING) – LOW G
X
Y
Z
EXAMPLE MEANING
mcu_temp Added mcu_temp to extended config. Delimiter '.' If 'mcu_temp' is given,
temperature string additionaly contains microcontroller temperature
tportxyz Set the default command port to xyz. As in the case with empty configuration
string, the new default value can be overwritten by sending a port number
through the control TCP connection.
VALUE
According to 802.3at Type 2
25.50 W (peak performance)
305 mA*
MANUAL CHANGE
Y
X
Z
15