Toro 2024 Directional Drill Software Manual page 16

Controller I/O Screen
To access this screen push button 6 on the I/O screen.
1. Seat switch
2. Exit side lockout
3. Carriage crash warning
Seat switch: shows an arrow out when nobody is in
the seat and a person in while you are in the seat.
Exit side lockout: changes from black to green when
in operation.
Carriage crash warning: a warning screen
59) will appear if:
•
the carriage is in the drill area and you try to
operate the loader arm or pipe cam or
•
you try to operate the carriage when the loader
arm or pipe cam is not in the home position.
Mud pump status:
•
Black icon: mud pump is off
•
Yellow icon: mud pump is in standby
•
Green icon: mud pump is in on
•
Green icon with 100: mud pump is in max flow
Mud pump flow: turns green when you actuate the
mud flow rocker switch.
Figure 58
4. Mud pump status
5. Mud pump flow
Figure 59
Travel Pendant I/O Screen
To access this screen push button 7 on the I/O screen.
The travel pendant screen shows the voltage and
position of the joystick located on the pendant.
g204521
The red dot is in the center of the target and the FNR
(forward, neutral, reverse) and Steer voltage shows
2.5 V prior to allowing the drill to move. If the red dot
travels outside of the outermost black ring, service or
replace the pendant. The indicators to the right and
left of the circle show the direction of the track travel.
The voltages show a range from 0 to 10.0 V.
(Figure
g210794
16
Figure 60
g034772