Cleaning; External Cleaning Of A Unit; Reason For The Job; Job Set-Up Information - Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List

TASK 21-22-91-100-801-A01
1.

External Cleaning of a Unit

A.

Reason for the Job

WARNING: – DO NOT BREATHE THE FUMES. THE SOLVENTS ARE DANGEROUS.
CAUTION:
Self-explanatory
B.

Job Set-up Information

(1) Consumable Materials
CODE REFERENCE
M09A LOCAL PURCHASE
C. Job Set-up
SUBTASK 21-22-91-620-001-A01
(1) Preparation of the Unit
(a)
D. Procedure
SUBTASK 21-22-91-160-001-A01
(1) External Cleaning of the Unit
WARNING: DO NOT USE DIPPING OR SPRAYING PROCEDURES FOR FULL UNITS.
(a)
(b)
E.

Close-up

Not applicable
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
– USE EYE PROTECTION. DO NOT LET THE SOLVENTS TOUCH YOUR SKIN.
– CLEAN THE PARTS IN A ROOM WHERE AIRFLOW IS SUFFICIENT.
– DO NOT CLEAN NEAR AN OPEN FLAME.
– CAREFULLY OBEY THE CLEANING PROCEDURES, OR REPLACE THEM WITH
A PROCEDURE WHICH IS SPECIFIED BY THE MANUFACTURER IF YOU USE
EQUIVALENT PRODUCTS.
– AFTER YOU COMPLETE THE PROCEDURE, YOU MUST PUT PROTECTIVE
CAPS OR APPLICABLE PACKAGING MATERIAL ON THE PARTS.
NOTE: Refer to the Consumable Materials Table (Ref. TASK 21-22-91-941-801-A01) for
all the data in the list.
Put all the protective caps on the units.
DIPPING OR SPRAYING PROCEDURES ARE ONLY FOR ISOLATED PARTS.
Clean the unit with a lint-free cloth made moist with cleaning material (M09A). As an
alternative, use a soft brush.
Dry with low-pressure compressed air, or with a lint-free cloth.
00001059

CLEANING

DESIGNATION
DENATURED METHANOL
21-22-91
Page 4001
Dec 15/06