Nokia FastMile 4G Installation Manual page 101

Nokia FastMile 4G Receiver Installation Guide
Issue: 01
iii Connect the male RJ 45 connector to the Ethernet port of the Nokia FastMile 4G
Receiver.
iv Slide the waterproof plug and gland to the Ethernet port of the Nokia FastMile 4G
Receiver and tighten securely to the port.
13 If you are installing a Compact mono-band model or ABA model of the Nokia FastMile 4G
Receiver and the Ethernet cable pre-attached to the Nokia FastMile 4G Receiver will not be
long enough to reach the residential gateway or PoE injector, make the cable longer by using
a waterproof IP67 female RJ 45 plug to attach additional cat5e shielded Ethernet cabling to
it. The maximum combined length is 80 m (262 ft).
14 Pass the Ethernet cable from the Nokia FastMile 4G Receiver through the hole that was
drilled in the wall, and use silicone or other waterproof sealing or caulking compound to seal
the hole.
Do not run the Ethernet cable to the residential gateway or PoE injector yet.
15 Confirm that the residential gateway that is going to provide service for the Nokia FastMile
4G Receiver is installed and powered up, or install and power up the residential gateway.
Nokia advises that a properly earthed wall socket should be used for powering the residential
gateway.
16 If the Nokia FastMile 4G Receiver is not going to be powered from the residential gateway,
set up a Nokia-approved PoE injector that is going to provide power over Ethernet to the
Nokia FastMile 4G Receiver, including connecting the PoE injector to the residential gateway
at the PoE injector's "LAN" port and to power. The following classes of PoE injector are
available from Nokia:
•
Class I: can comply with EN 60950-1 if grounding is provided on the wall socket; should
be put as close as possible to the place where the Ethernet cable enters the home; see
section 6.2 for more information
•
Class II: can comply with EN 60950-1 if no grounding is provided on the wall socket; can
also be used if grounding is provided on the wall socket; see section
information
Figure 55 shows the location of the "LAN" port on a PoE injector. Specifics of the set up will
depend on the PoE injector and residential gateway.
3TG-00387-ABBA-TCZZA
Mounting and connecting the Nokia FastMile 4G
Receiver
6.2 for more
95