ABB SACE Emax 2 Manual page 24

Settings Menu
22 | © 2019 ABB | 1SDH001316R1002 - ECN000086501 - Rev. A
Menu Submenus
Configuration
Hardware Trip
T Protection
Circuit Breaker
Neutral Protection
Earth protection
Installation
Main Frequency -
-
Phase Sequence
Local/Remote
Local Bus
Modules Modul x
BLE
Functions
Monitor time -
Test Bus -
Enable
Power Controller
(4)
-
Enable
Load Shedding
(4)
-
Enable
Network Analyzer
(6)
-
Enable
Datalogger
(6)
-
Enable
Dual Set
(6)
Default set
Date
Time
System
Language
New PIN
View -
YO Command
Functions
YC Command
Maintenance Alarms
(1)
with CB in 3P configuration
(2)
available with CB in 4P or 3P with neutral configuration
(3)
the menu populates with the list of accessory modules detected by the unit with Local Bus activated and in
the envisaged connection and supply conditions
(4)
available if the function has been installed in the Trip unit
(5)
additions are only made to the list of the specific submenu when the function is enabled (=On)
(6)
available if provided for by Trip unit model or if relative SW package has been activated
(7)
available with LSIG versions
Description and parameters
Phase number selection
Protection activation command
Protection activation command
Enable, Neutral threshold
(2)
External sensor configuration
(7)
Installation of modules
Grid frequency configuration
Phase sequence configuration
Parameter writing configuration
Configuration of local bus presence
Details in chapters of each module
(3)
LV communication configuration
Switch On LOCAL, Signalling RESET
Measuring range configuration
Test bus activation
(5)
Function enabling and parameters: see manual
1SDH001330R1001
(5)
Function enabling and parameters: see manual
1SDH001330R1001
(5)
Function enabling and parameters: see manual
1SDH001330R1001
(5)
Function enabling and parameters: see manual
1SDH001330R1001
(5)
Function enabling and parameters
Configuration of unit date
Configuration of unit time
Configuration of menu language
PIN Configuration
Representation parameters of menus
and measurements: see manual
1SDH001330R1001
Function, Delay
Activation of maintenance signals
ABB | SACE Emax 2
Interface and menus | 4 - Menu