Sealey PRK01 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear
instruction protective
manual gloves
1. SAFETY
Study, understand and follow all instructions before using this product.
9
Use only on a hard, level surface.
9
Failure to heed these instructions may result in personal injury and/or property damage.
9
Inspect before every use. DO NOT use if cracked or deformed. No alterations shall be made to this product.
9
NOTE: Maximum recommended tread width 290mm.
Ensure the ramps are set to the correct width for the vehicle being raised, centred against the tyres and are laid out parallel to each other.
9
Be sure the wheels to be driven onto the ramps are positioned straight forward and in alignment with the ramps.
9
Have a second person, standing clear from vehicle, watching the ramps as the vehicle is driven on or off of the ramps to warn of any
9
unwanted movement and to ensure correct alignment.
Proceed slowly and cautiously without acceleration or applying brakes suddenly when driving on or off the ramp. Once the vehicle
9
reaches the end of the ramps, apply brakes to prevent overtravel and ensure that the vehicle wheel rolls fully into the dished portion of
the ramp.
Place vehicle in neutral and release brakes. The vehicle should not move.
9
Set handbrake. Place vehicle in reverse gear or park (auto).
9
Securely chock wheels at opposite end to dished portion using suitable equipment.
9
Be sure that all tyres are properly positioned on the support platform. Using caution to position your body clear of danger, shake
9
vehicle sideways and endways to ensure the vehicle and ramps are stable. Check that ramps have not become damaged or bent
during loading.
DO NOT exceed the rated capacity of the ramps (2000kg each, 4000kg per pair).
8
DO NOT use this product for any purpose other than that for which it is designed.
8
DO NOT use the ramps if they are in any way damaged.
8
DO NOT use other lifting equipment in conjunction with the ramps.
8
2. INTRODUCTION
Manufactured from durable polypropylene. Suitable for professional or serious DIY applications. 350mm wide ramps for broad range of
vehicles. Allowing easy access to the underside of the vehicle - recommended maximum tread width 290mm. 4tonne maximum capacity -
2tonne per ramp. Easy to remove and reattach the simple interlocking sections.
3. SPECIFICATION
Model no: ....................................................................PRK01
Load capacity per pair: ...................4tonne (2tonne per ramp)
Extended dimensions (L, W, H) ...........2 x (4655 x 350 x 170)
Max. tread width ......................................................... 290mm
Nett weight: .................................................................... 76kg
Components:
Slope block (fig.2) ................................................................ 2
Body block (fig.3) ............................................................... 10
End block (fig.4) ................................................................... 2
© Jack Sealey Limited
PIT RAMP KIT - 4 TONNE
MODEL NO:
Wear
protective
footwear
Original Language Version
PRK01
fig.1
PRK01 Issue 1 10/01/19