Advertisement
1.
Take the Luminaire out of the packing Box.
3.
Unscrew the M4x8 Retainer Screw to open the
driver cover and to have access to the electrical
connections.
Note: Driver cover has Self retaining screws.
5.
Loosen the Gland with the help of box
spanner and insert the wire from the Pole
mounting side. Take wire length of 80mm
inside the compartment.
All the pictures in the MI sheet are representative only and may vary from the Actual Product.
2.
For pre-wired luminaire, directly connect it to the
incoming Power Cable. Wires to be properly
terminated to ensure safety, preferably using a IP65
sealed connector (not part of supply).
Ensure ground wire is properly connected.
For non-prewired luminaire follow the instructions
as per the steps defined.
4mm
Fig. 1
4.
Firstly, remove the LED Engine connections. Care
to be taken through out the process to not to
create any type of pull force on any of the LED
Engine wires.
Then, loosen the three M4 screw slightly, then
rotate the gear tray in ant-clockwise direction and
take the gear tray out of the housing.
Fig.3
6.
Tighten the Gland with the help of box
spanner with a torque of 2 to 2.5 Nm.
Fig. 5
Fix the driver tray as shown in the figure.
7.
Care to be taken that no force to be applied on
earthing wires during the process.
Rotate the driver gear tray in clockwise direction to lock
the gear tray in between screws, then, fix it by tightening
the loosen screws
Fig. 2
9.
Secure the Gasket on the housing rib. Place the
Screw the M4x8 Captive screw to close the
Driver Cover on the housing matching with the
driver cover.
profile of gasket.
DRIVER
OUTER
SIDE
SIDE
Fig.4
This luminaire is suitable for Pole of outer
11.
Dia 48mm to Dia 60mm. Tighten the screws
with a torque of 8Nm.
4mm
Fig. 6
All the pictures in the MI sheet are representative only and may vary from the Actual Product.
Make the electrical connections in 3 pole connector
8.
as per the LNE marking. Then, connect the LED
Engine wire connections with the driver output.
L
Fig. 7
Tighten the M4 Retainer Screw after properly
10.
placing the Driver Cover with initially a torque of
1Nm, then finally tighten with a torque of 1.2Nm.
Fig. 9
Fig. 11
N
40 mm
8-9 mm
O 8-10 mm
Fig. 8
Fig. 10
Advertisement
