Acer AT4202P Service Manual page 40

5. Click the Prog key , it will show duologue window as picture 5 ,it start to write he soft ware ,
6.
RE: It will use about 3 minute to write soft ware, Do not turn-off the PDP during that time;
otherwise it will make the Flash IC break.
7. Finish writing, it will show duologue window as picture 6, it mean end, click OK.
Clicking DELINK key .then CLOSE key exit the programme.
8. Turn-off the PDP. Pull out RS232 wire. then turn-on the PDP and enter factory menu，watch the edition of
soft ware whether or not the same with edition of writing.
figure 5
figure 6
Page 40 of 99