Sealey LED014 Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL
Ensure the lamp is fully charged before initial use.

DO NOT turn the lamp on when it is being charged.

DO NOT shine directly into your, other person's or

animal's eyes.
DO NOT allow children to use the lamp.

DO NOT handle or move the lamp whilst it is being

charged.
DO NOT use the lamp if you suspect that the battery or

the lamp casing is damaged.
DO NOT leave battery in a discharged state, recharge

battery immediately. Before storage, fully recharge the
battery, subsequently recharge the battery at least once
every six months of non-use.
1.2. ELECTRICAL SAFETY FOR USE OF CHARGER.
USE ONLY THE SUPPLIED CHARGER PLUG FOR
CONNECTING TORCH TO THE POWER SUPPLY.
WARNING! It is the user's responsibility to read,

understand and comply with the following electrical
instructions:
You must ensure the risk of electric shock is minimised
by the installation of appropriate safety devices.
An RCCB (Residual Current Circuit Breaker) should be
incorporated in the main distribution board. We also
recommend that an RCD (Residual Current Device) is
used with all electrical products, particularly portable
equipment which is plugged into an electrical supply not
protected by an RCCB.
You must also read and understand the following instructions
concerning electrical safety.
1.2.1. The Electricity At Work Act 1989
requires all portable electrical appliances, if used on
business premises, to be tested by a qualified electrician,
using a Portable Appliance Tester (PAT), at least once a
year.
1.2.2. The Health & Safety at Work Act 1974 makes owners
of electrical appliances responsible for the safe condition
2. INTRODUCTION / SPECIFICATION
Robust yet lightweight inspection lamp for the professional user. Removable Lithium-ion battery allows additional battery use for
continuous operation, (additional batteries sold separately). Incorporates 30 (LED014) or 60 (LED015) super bright LEDs ideal for
use in engine bays and for under-body inspection. An additional 3 LEDs indicate the battery level. 360° Swivel hanging hook for
hands-free applications. Supplied with mains charger.
Battery: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3.7V / 1Ah Li-ion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.2V / 1Ah Li-ion
Charging Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4hrs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6hrs
Operating Time: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6hrs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4hrs
Operating Temp: . . . . . . . . . . . . . . . . . . . . . . . . . . . -5°C ~ 45°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -5°C ~ 45°C
Storage Temp: . . . . . . . . . . . . . . . . . . . . . . . . . . . . -20°C ~ 40°C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -20°C ~ 40°C
Replacement Battery Pack . . . . . . . . . . . . . . . . . . . . LED014BP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LED015BP
INSTRUCTION MANUAL FOR:
CORDLESS 30 / 60 LED RECHARGEABLE
INSPECTION LAMP - Lithium - ion
MODEL No's.
of the appliance and the safety of the appliance operator.
If in any doubt about electrical safety, contact a
qualified electrician.
1.2.3. You must ensure that you:
Inspect the charger plug, cable and connector for wear

and damage to ensure items are safe before connecting
to the mains power supply.
If worn or damaged DO NOT use.
Important: Check that the voltage marked on the charger

plug is the same as the power supply to be used.
Uncoil the cable between charger and the lamp.

DO NOT pull the charger plug from the mains socket by

the lead.
WARNING! DO NOT use any other type of charger with

this product, other than the supplied mains or car
charger. Failure to observe this warning could result in
injury and or fire and will invalidate the warranty.
DO NOT try to take the charger plug apart.

DO NOT use the charger plug to charge or power any

other electrical item.
DO NOT get the charger wet, or use in wet, damp

conditions (for indoor use only).
1.3 Battery Safety
WARNING! To reduce the risk of burns or fire:

DO NOT Attempt to open, disassemble, modify or

service the battery pack.
DO NOT Crush, puncture, short external contacts or

dispose of in fire or water.
DO NOT Expose to temperatures above 60°C (140°).

Replace only with the battery pack designated for this

product.
Recycle or dispose of used battery as stipulated by local

regulation.
If the electrolyte in the cells gets on your skin, thoroughly

wash with soap and water. If it gets in your eyes, rinse
thoroughly with cool water and seek immediate medical
attention
LED014
Original Language Version
LED014, LED015
LED014, LED015 Issue: 2 - 16/10/09
LED015