Advertisement
SCSI Feature
The system board features a single-chip SCSI host adapter that adds
SCSI I/O capability to the system. The chipset consists of an onboard
microcontroller, bus master interface controller, and SCSI controllers. A
50-pin Fast SCSI-II interface with 10 MB/s transfer rate and a 68-pin
Wide SCSI interface that transfers at 20 MB/s (Wide SCSI) and
40 MB/s (Ultra SCSI) are also onboard to accommodate various SCSI
devices.
Using the SCSI Feature
Follow these steps to use the SCSI feature:
1.
Install a SCSI device in the system and connect it to the SCSI
interface on the system board. Please refer to the system board's
user's manual for the location of the SCSI interface.
2.
Enter the BIOS utility to set the corresponding SCSI parameters.
3.
Enter the SCSI Configuration Utility and make the necessary
changes.
For more information about the installation procedures under different
operating systems, read the README.XXX in the subdirectory of the
target operating system.
10
User's Guide
Advertisement
