Download Print this page

NEC 4xi Manual page 3

Projector communications kit

Advertisement

NEC Installation
______ Secure all of the connector screws.
____________ For the NEC XG: always apply AC power to the projector and place it in Stand-
NEC Memory Assignments
__________ System 4xi can support a maximum of 22
Extron • System 4 xi xi xi xi xi Switcher Series • User's Manual • P/N 68-413-02 Rev. E
6. Plug the 15-pin HD connector of the Projector Communications Extension cable
(shown as CC 50') into the PJ Comm port on the System 4xi. The other end has
a 9-pin female connector. Plug this into the other 9-pin male D connector on the
NC COM adapter.
7. Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV
cable onto the System 4xi output and those on the other end onto the matching
BNCs on the NEC connector panel. See cable diagram.
8. Power up the projector and set the projector as follows:
• if your system has less than 10 inputs, set the projector to SW_Level 1 mode
• if your system has 10 or more inputs, set the projector to SW_Level 2 mode
9. Apply AC power to the System 4xi.
by power before applying AC power to the System 4 xi . This procedure must be
followed anytime AC power to the system has been interrupted or the CC cable
detached. Failure to follow this AC power up sequence will cause
communication errors.
The following two examples and accompanying tables provide information for
setting up the NEC projector (not the System 4xi). Please refer to the projector
documentation for further details.
The table on the right lists the Extron channel assignments and the
corresponding NEC host and peripheral slot
assignments using Extron System Switchers.
The physical location of the Extron channel
assignments will depend on the system
setup.
The tables and charts in the examples below
illustrate System Switcher channel
assignments for NEC models PG, PG+, PGX
and XG.
channels: 1 System 4xi ( host ) looped to
multiple System 10 Switchers ( peripherals ).
Configuration and Connections
EXTRON
NEC SLOT
CHANNEL
ASSIGNMENT:
HOST
NUMBER
1
M01
2
M01
3
M01
4
M01
5
M01
6
M01
M01
7
8
M01
9
M01
10
M01
11
M02
12
M02
13
M02
14
M02
15
M02
16
M02
17
M02
18
M02
19
M02
20
M02
21
M03
22
M03
23
M03
96
M10
97
M10
98
M10
99
M10
100
M10
NEC SLOT
ASSIGNMENT:
PERIPHERALS
S01
S02
S03
S04
S05
S06
S07
S08
S09
S10
S01
S02
S03
S04
S05
S06
S07
S08
S09
S10
S01
S02
S03
S06
S07
S08
S09
S10
Page 3

Advertisement

loading

This manual is also suitable for:

26-472-0126-458-0126-494-0126-467-01