HP ProCurve Radio Port 210 Product End-Of-Life Disassembly Instructions page 2

2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Torx Driver with center cavity (tamper-resistant)
Philips Screw Drive
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove chassis mounting screws on bottom, by using torx driver with center cavity screw driver.
2. Separate plastic enclosure and PCAs.
3. Remove 2 screws from the PCA holding radio shield and remove shield.
4. Remove antenna PCA from the plastic cover by pulling holding tabs outward.
5.
6.
7.
8.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision A
Tool Size (if
applicable)
# 10
#2
Page 2