Page 1
PV panel Replacement-UrbanSpark The battery presents a risk of electrical shock and a high short circuit current. The Philips mounting instructions must be strictly followed, otherwise potential application, reliability or safety issues may arise. Only a qualified Philips service representative who is knowledgeable in product and the required precautions is permitted to replacement . Keep unauthorized person away from the product during the replacement.
Page 2
PV panel Replacement-UrbanSpark Broken PV panel 10. Pull out the broken PV panel at a distance of 20cm to the bottom pole carefully, and take out the plugs from the pole. carefully disconnect the plugs, then remove the broken PV panel. Rubber mat 11.
Page 3
PV panel Replacement-UrbanSpark 13. Push the good PV panel at a distance of 20cm to the bottom pole, and connect the plugs until you hear a “click” sound, then put the plugs into the pole through the hole. 14. Push the good PV panel to the end. 16.
Page 4
PV panel Replacement-UrbanSpark Note: Whoever installs the system takes full responsibility for safety during this process Pull 20. Affix the pole with M20 Nuts, spring washers and flat washers 19. Erect the Pole carefully 21. Put battery into the pole. 22.