Table of Contents
Advertisement
Installing a Water Bottle
1. Open the lower door.
2. Hang the probe assembly on probe hanger.
3. Place a fresh bottle outside the cabinet.
4. Clean the outside of new bottle with a cloth.
5. Insert the probe into the bottle.
6. push the probe assembly down
and until the tube hits the
clicks in place
bottle of the bottle.
7. Slide the bottle into the cabinet and the close
door.
Supply Electricity
First, make sure that the two switches at the rear top portion of the unit are turned OFF.
If these switches are turned ON when the plug is inserted into an outlet, the water dispenser
will be damaged. Plug the power supply cord into a properly-grounded wall outlet. The pump
will then start to move water from the water bottle to the hot and cold tanks and it will take
around 3~4 minutes to ll both tanks for the rst time. During this period, the pump will
continuously run and this is normal.
portion of the unit
Probe
assembly
ward
until it
cooling
switch
(Green)
7
probe
hanger
lower door
ON
ON
OFF
OFF
at the rear top
heating
switch
(Red)
Hide quick links:
Advertisement
Table of Contents
