Toshiba SF-P2218EEU Instructions Manual page 16

[Temperature sensor short circuit and open circuit protection]
In whatever mode, when short circuit or open circuit protection occurs to the temperature
sensor, digital screen displays E1 or E2 and blinks unceasingly, any key does not work,
and buzzer rings for 10 times.
[Safety protection]
In the power-on mode, when room temperature Th exceeds 50°C, the system closes all
outputs, the digital screen displays "FF" and blinks at the frequency of 1 time per second,
any key does not work, and only power-off can quit protection.
[Toppling over protection function]
No matter in power-on or power-off mode, when the machine topples over, the system
immediately shuts down all heating components and displays "E3", any key does not work.
[Close key fancy light and buzzer]
In the power-on mode, press at the same time the "timing key" and "shift key" for 2 seconds
to close key fancy light and buzzer output. Repeat this action to open them.
[Children lock function]
time for 2 seconds to open the children lock function. Repeat this action to close it.
[Automatic power-off function]
Screen displays "--" if the heater is not under Temperature Control mode. When the timer
function is off, the heater will automatically shut off with no operation during 12 hours.
[Remote-control unit]
The use of remote-control unit: Key function is consistent with machine body control panel.
Note: Strong warm wind mode can be opened by pressing " " key on remote-control
unit.
[Intelligent mode]
In the Intelligent mode, press "+" and "-" keys to set wanted temperature. When environ-
ment temperature is lower than set temperature (by more than 2°C), the product heats in
high warm wind mode; when environment temperature is close to the set temperature (by
less than 2°C or more), the product heats on low warm wind mode; when environment
temperature is higher than set temperature, the product stops heating.
14