Table of Contents
Advertisement
Faults and what to do about them
en
Faults
Drying time too long?
Display panel goes off
and Start button flashes.
Humidity in the room
increases.
Power cut.
Unusual noises when dry-
ing.
The dryer feels cold
despite drying.
* Depending on the model
If you cannot rectify the fault yourself by turning the dryer off and then on
Note:
again, please contact our after-sales service.
24
Cause/remedy
The fluff filter or the EasyClean filter may be dirty, which will make the dry-
■
ing time longer. Clean the fluff filter or the EasyClean filter.
If the air inlet on the dryer is blocked or not freely accessible, this may
■
increase the drying time. Make sure that the air inlet remains unobstructed.
If the ambient temperature is higher than 35 °C, this may extend the drying
■
time.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Not a fault. Energy-saving mode is active ~ Page 7.
Not a fault. Make sure the room is sufficiently ventilated.
The drying programme is interrupted. Remove the laundry and spread it out, or
restart the programme.
Not a fault; see also ~ Page 21.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.
Advertisement
Table of Contents
