Mitsubishi Electric 800 Series Instruction Manual page 30

 Performing tuning
POINT POINT
• Before performing tuning, check the monitor display of the operation panel or parameter unit if the inverter is in the
state ready for tuning. Turning ON the start command while tuning is unavailable starts the motor.
• In the PU operation mode, press
For External operation, turn ON the start command (STF signal or STR signal). Tuning will start.
NOTE
• The motor shaft is rotated about 180 degrees during tuning.
• The following shows the monitor display/indicator on the operation panel (FR-DU08), the parameter unit (FR-PU07), and the
LCD operation panel (FR-LU08) during tuning.
Status Parameter unit (FR-PU07) display
TUNE
Setting
During
TUNE
tuning
STF
TUNE
Normal
COMPLETION
completion
STF
30
VECTOR CONTROL
/ on the operation panel.
Operation panel (FR-DU08)
READ:List
1
STOP PU
2
FWD PU
3
STOP PU
display/indicator
Flickering
LCD operation panel (FR-LU08) display
AutoTune 12:34
TUNE
--- STOP PU
PREV NEXT
AutoTune 12:34
TUNE
STF FWD PU
PREV NEXT
AutoTune 12:34
TUNE
Completed
STF STOP PU
PREV NEXT
1
2
3