Sealey RE229.V3 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
wear eye
refer to
Protection
instruction
manual
1. safety
Danger! Stop compressing the spring before the coil windings touch, fig.2.A. Exercise particular caution when using an air impact
V
wrench.
Warning! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
R
equipment.
Warning! Wear approved safety eye protection (standard spectacles are not adequate).
R
Warning! Do not compress the spring to an extent where the jaws touch, fig.2.B.
R
Do not operate spring compressor if parts are damaged or missing as this may cause failure and/or personal injury.

Do not force the spring compressor to achieve a task it was not designed to perform.

Do not allow untrained persons to use the spring compressor.

Familiarise yourself with the applications, limitations and potential hazards of the spring compressor.

Maintain the spring compressor in good condition. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may

be dangerous and will invalidate the warranty.
Keep the work area clean, uncluttered and ensure there is adequate lighting.

Keep hands and body clear of the spring when operating the spring compressor.

Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.

Remove ill fitting clothes. Remove ties, watches, rings, other loose jewellery. Contain and/or tie back long hair.

Wear appropriate protective clothing.

When not in use, clean and store the spring compressor in a safe, dry, childproof location.

2. introDuction
suitable for MacPherson strut coil springs. Features a yoke extension bracket that also allows use on conical springs. Supplied with three
pairs of different sized interchangeable yokes, for a wide range of vehicle applications and plastic yoke protectors that protect the spring
coating from damage which can invalidate the vehicle manufacturer's warranty. Safety yokes carefully shaped to stop the spring bowing while
under compression.
3. specification
model no: ..............................................................re229.V3
capacity: .................................................................... 2500kg
Yoke Specification (Size/Suitability): ......................................
Gold Yokes: ........................................................ Ø80-105mm
Black Yokes: ........................................................ 105-140mm
silver Yokes: .................................................... Ø145-190mm
maximum jaw opening:............................................... 265mm
drive: .................................................................... 21mm hex
4. Description
refer to fig.1
4.1 The compressor consists of a solid steel body mounted with two forged
jaw interlocks, one on the body and the other on a centrally mounted spindle.
1 Retaining bolts
2 Yoke
3 Compressor body 7 Outer rib
4 Hex nut
© Jack Sealey Limited
instructions for
professional coil spring compressor set
2500kg
model no:
5 Spring
6 Safety clips
Original Language Version
re229.V3
fig.1
rE299.V3 | Issue 2(I) 23/09/15