Sealey VS1830.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS

WARNING! Ensure all Health and Safety, local authority,
and general workshop practice regulations are strictly
adhered to when using tools.

DO NOT use tools if damaged or worn.

Maintain the tools in good and clean condition for best
and safest performance.

Ensure all threads are clean and well lubricated.

Always check that remover is correctly assembled and is
square with the workpiece.

Wear suitable clothing to avoid snagging. Do not wear
jewellery. Tie back long hair.

Wear approved eye protection. A full range of personal
safety equipment is available from your Sealey dealer.

DO NOT hit workpiece or remover with a hammer if
workpiece has not moved with maximum force applied.
DO NOT use the tool without the locknut correctly fitted

in conjunction with the associated die.
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or proprietary manual, to establish the correct
procedure and data. These instructions for use are provided as a guide only.
2. DESCRIPTION & SPECIFICATION
Interchangeable piston adaptors, one for full skirt pistons that makes 360° contact with the cylinder, and a short skirt piston adaptor
designed for use with slipper pistons. Suitable for use with most types and sizes of pistons. Supplied with 4 additional aluminium
pin adaptors, for protecting the gudgeon pin. These four additional adaptors will allow the puller to work with any size gudgeon pin
from 13mm to 24mm.
Shaft Ø: 8mm
Die Ø: 13, 16, 19, 22mm
Maximum Piston Ø: 95mm
Maximum Travel: 110mm
Ø13
Ø16 Ø19
Dies
© Jack Sealey Limited
INSTRUCTIONS FOR:
GUDGEON PIN REMOVER - MOTORCYCLE
MODEL No: VS1830.V2
Threaded rod
Ø22
Original Language Version
Full skirt piston adaptor
Main body
Short skirt piston adaptor
VS1830.V2
Fig.1
Fig.2
Issue: 1 - 13/01/14