Miele F 2462 SF Operating And Installation Instructions page 103

Influent hallenge
ubstance
concentration
DEET 1,400 ng/L ± 20%
Phenytoin 200 ng/L ± 20%
Metolachlor 1,400 ng/L ± 20%
Ibuprofen 400 ng/L ± 20%
Trimethoprim 140 ng/L ± 20%
Linuron 140 ng/L ± 20%
Naproxen 140 ng/L ±20%
Estrone 140 ng/L ±20%
Bisphenol A 2,000 ng/L ±20%
Nonyl phenol 1,400 ng/L ±20%
Tested using a flow rate
NOTE : The testing was performed under standard laboratory conditions, actual performance may vary.
Service low rate
Water ressure
Water emperature
Function
Capacity
Warning : Do not use with water that is microbiologically unsafe or of unknown quality without ad-
equate disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cyst.
Notice :
- Adsorption media will not be regenerated and used.
- Systems must be installed and operated in accordance with manufacturer's recommended procedures
and guidelines. The system and installation shall comply with applicable state and local regulations.
Install on cold water line only.
- Flush 3 gallons through filter before use ( lush approximately 5 minutes).
- To maintain proper filtration, replace the filter
Manufacturer : Microfilter co.,Ltd.
15-1, GWINONG3-GIL, DEOKSAN-MYEON, JINCHEON-GUN, CHUNG-BUK 27856, KOREA
Phone : +82-43-531-7022/7024
Average eduction
>98.7%
>94.4%
>98.7%
>95.3%
>96.7%
>96.6%
>96.2%
>96.3%
>99.0%
>96.3%
55 ,
30
WFS200MF 250 gallons (946 L), WFS210MF 150 gallons (567 L)
Reduction
requirement
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
essure of 60 i ,
0.55 gpm (2 m)
125 psi (206 – 861 k a)
35 100 °F (2 38 °C)
hemical/ echanical
every 6 months.
Water filter
Max ermissible roduct
water concentration
200 ng/L
30 ng/L
200 ng/L
60 ng/L
20 ng/L
20 ng/L
20 ng/L
20 ng/L
300 ng/L
200 ng/L
temperature of 68 ± 5
103