Advertisement
3. SPECIFICATION
MODEL NO.: ................................................................ DPF1
Air receiving tank ............................................................ 15ltr
Air requirement ............................................................4-6bar
Cleaning agent .........................................Chemical/Water/Air
Dimensions (W x L x H) ........................ 400 x 900 x 1120mm
Supply ................................................................. 230V~50Hz
Power ................................................................................5W
4. CONTENTS
fig.1
5. OPERATION
5.1.
DPF PREPARATION
5.1.1.
Select a suitable adaptor and gasket (fig.1-1, fig1-2, fig1-3) for the DPF. Ensure a good fit to the DPF to avoid spillage. Close off the
adaptor using the Soaking Cap (fig.1.10). Block off any DPF pressure tappings.
5.1.2.
Pour Ultra Clean detergent into inverted DPF and fill to the top
face of the internal structure.
5.1.3.
Leave the DPF in a vertical position for minimum of 30 minutes
and regularly agitate it in order to ensure full coverage of solution
within the DPF and to begin the cleaning effect.
5.1.4.
Empty the contents into a suitable container after soaking the
DPF for a suitable period.
5.2.
OPERATION PREPARATION (fig.4)
5.2.1.
Ensure that the unit is not connected to the power supply.
5.2.2.
Lay drained DPF onto machine bed ensuring the DPF outlet is
beyond the brushes at the machine entrance.
NOTE: If the outlet of the DPF does not fit fully into the aperture
on the machine, remove the cover by using the three
thumbscrews on the face plate and fully engage the DPF into
the exposed space.
NOTE: Some PDFs are not designed as 'straight-through' e.g.
they may be 'L' or even 'Z' shaped. In certain circumstances it is
advised to remove the aperture entrance cover, fit the discharge
adaptor (fig.1.8) in place of the cover and attach the clear pipe
(fig.1.6) between the adaptor and the DPF.
5.2.3.
Strap DPF firmly to the machine bed using the supplied ratchet
bars (fig.1.7).
5.2.4.
Remove Soaking Cap from DPF and connect air supply to the
adaptor fitted to the unit.
5.2.5.
Fill the water pressure container (fig1.11) with the appropriate
amount of water that DOES NOT exceed the capacity of the
waster bucket.
5.2.6.
Connect the water supply fitting to the inlet of the air line fitting
(fig.3). Ensure that the water outlet valve is closed at this stage.
NOTE: Ensure cover plate is placed with the arrow facing
the machine entrance (see diagram right).
© Jack Sealey Limited
Original Language Version
Item
Part No.
No.
1
DPF01.01 Adaptor 1 + Gasket
2
DPF01.02 Adaptor 2 + Gasket
3
DPF01.03 Adaptor 3 (Small Vehicle)
6
DPF01.06 DCS Clear Hydraulic Pipe (1-1/4"F to
1-1/4"F) 1.5m
7
DPF01.07 Mini Ratchet Bar (25mm x 1.5m)
8
DPF01.08 Discharge Adaptor (Small)
9
DPF01.09 Waste Water Hose (38mm)
10
DPF01.10 Soaking Cap (1-1/4)
11
DPF01.12 Water Pressure Container
12
DPF01.13 Waste Water Bucket
DPF1
Issue 2 (5)
Description
23/09/20
Advertisement
