Bosch Smart Home Twinguard Faqs

FAQs for Twinguard Single Point Solution
Question
What is the Bosch Smart Home
Twinguard?
How does the reset of the
Bosch Smart Home Twinguard
work?
How do I install the
Twinguard?
Answer
The Bosch Smart Home Twinguard is one of
the world's first 2-in-1 smoke alarms. It is a
combination device consisting of smoke
detector with Dual-Ray technology and air
quality sensor. With the Bosch Twinguard App,
you can be connected to your Twinguard at any
time, from the road or at home. So you can get
immediate information about smoke alarms in
your home on the go. In addition, you have
access to your air quality data at any time and
from anywhere. Further information on the
Bosch Smart Home Twinguard can be found
here in the corresponding data sheet and on
product page
the .
To restore the factory settings, please proceed
as follows:
1. First remove at least one battery. Please wait
20 seconds or briefly press the control button of
your Twinguard again after removing the
battery. This will ensure that you can
successfully restore the factory settings.
2. Then reinsert the battery and press and hold
the control button while inserting.
3. The detector will now start with a fast flashing
orange light.
4. Release the control button briefly and then
immediately press the control button on the
detector again for at least four seconds until
you hear a short acoustic signal.
5. The Twinguard then restarts and a flashing
green light indicates that the factory settings of
your Bosch Twinguard have been successfully
restored.
The Bosch Smart Home Twinguard can be
installed in just a few simple steps. All you need
is the Bosch Twinguard App, an already
installed gateway and the accessories included
in the packaging. After starting the Bosch
Twinguard App, it guides you through the
individual installation steps. The easiest way is
to take a look at the step-by-step instructions in