Panasonic AK-HRP1000G Operating Manual page 34

Item
GENLOCK PHASE This is used to adjust the horizontal phase during genlock.
TALLY CONTROL Sets whether or not to notify the camera when there is a tally input from the <PREVIEW> connector.
When this is set to "ON", notification is sent if there is a tally input when the camera set in [TALLY INPUT] is
selected.
This is enabled when other than "Serial", "LAN", "Serial(AK)", and "LAN(AK)" is set in [CONNECT
SETTING].
TALLY INPUT Sets the camera to be notified of a tally input when [TALLY CONTROL] is set to "ON".
This is enabled when other than "Serial", "LAN", "Serial(AK)", and "LAN(AK)" is set in [CONNECT
SETTING].
TALLY SIGNAL Displays the tally input status of the <PREVIEW> connector.
"ON" is displayed when there is tally input, and "OFF" is displayed when there is no tally input.
TALLY CONT MD Sets the method for sending tally notifications to the camera.
SELECT
Sends tally notifications to the camera in accordance with the [TALLY CONTROL] and [TALLY INPUT]
settings.
DIRECT
Sends tally notifications to the camera currently connected with the unit.
If the unit is connected to another camera when there is tally input from the <PREVIEW> connector and
[TALLY CONTROL] is "ON", be careful because [TALLY CONTROL] will not be set to "OFF" for the cam-
era before the connection is switched.
Furthermore, [TALLY CONTROL] will be set to "ON" for the newly connected camera in this case.
ROP Menu (during AW-UE100 connection)
Setting details
- 34 -