7.3.10 Operating Mode - GE Multilin EPM 2200 Instruction Manual

7.3.10 Operating Mode

Parameter designator
Available by Software
Option (see Order Code
VOLTS L-N
VOLTS L-L
AMPS
W/VAR/PF
VA/Hz
Wh
VARh
VAh
Note
7–14
Refer to Programming the Configuration Mode Screens above for details on changing
values. The three protocol selections are shown below.
3. Press ENTER to scroll through the other
4. Press DOWN or RIGHT to display the Password screen (see Reset Mode on
page 7–4 for details).
5. Press MENU to return to the main Configuration menu.
Operating mode is the EPM 2200 meter's default mode. If scrolling is enabled, the meter
automatically scrolls through these parameter screens after startup. The screen changes
every 7 seconds. Scrolling is suspended for 3 minutes after any button is pressed.
Push the DOWN button to scroll all the parameters in operating mode. The active
parameter has the indicator light next to it on the right face of the meter.
Push the RIGHT button to view additional displays for that parameter. A table of the
possible displays in the operating mode is below. Refer to Appendix A for a detailed
navigation map of the operating mode.
Table 7–1: Operating Mode Parameter Readings
table)
A1, B1, C1 VOLTS_LN
A1, B1, C1 VOLTS_LL
A1, B1, C1 AMPS
B1, C1 W_VAR_PF
B1, C1 VA_FREQ
C1 KWH_REC
C1 KVARH_ POS
C1 KVAH
Readings or groups of readings are skipped if not applicable to the meter type or hookup,
or if explicitly disabled in the programmable settings.
CHAPTER 7: CONFIGURING THE METER USING THE FRONT PANEL
CFG
Possible Readings
VOLTS_LN_ MAX VOLTS_LN_ MIN
VOLTS_LL_ MAX VOLTS_LL_ MIN
AMPS_NEUTRAL AMPS_MAX
W_VAR_PF W_VAR_PF
_MAX_POS _MIN_POS
VA_FREQ_ MAX VA_FREQ_ MIN
KWH_DEL KWH_NET
KVARH_ NEG KVARH_ NET
EPM 2200 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
parameters.
AMPS_MIN
W_VAR_PF W_VAR_PF
_MAX_NEG _MIN_NEG
KWH_TOT
KVARH_TOT