Mitsubishi Electric PAC-SG59SG-E Installation Manual

Air Outlet Guide
Photo
Dimensions
49.7
* Air Guide prevents reverse rotation of outdoor unit fan when it enters low speed rotation mode with fan controller
being operated. It is also used for protection of fan when strong winds, such as a typhoon, wind blowing through tall
buildings, etc., directly strike the air outlet. In addition, installation of this product is necessary when cooling opetation
is to be performed in outdoor tempreture of -5℃ or lower (down to -15℃).
Note the followings when installing this guide:
1) Be sure not to use "upward discharge" in a place where snowing is possible. Snow may accumulate in the
guard, which could damage the fan, etc.
2) Attaching this unit will decrease the performance (by 2-3%) and increase noise from outdoor unit (by approx. 1-2 dB).
3) Do not use "upward discharge" when there are any obstacles at the back and on both sides of outdoor unit
(air is taken in from top of unit): This could cause a short cycle.
4) To eliminate the influence of external wind, be sure to install the unit with its back facing to wall.
5) Do not install this unit in a place where wind directly blows to the back of the unit.
E-258
(to change air blowing direction)
Unit: mm
559 (Installation pitch of air outlet grille and support)
CAUTION
PAC-SG59SG-E
Descriptions
A part to change air direction from outdoor unit.
Can also be used to prevent short cycles.
Applicable Models
PUZ-ZM60VHA
PUZ-ZM71VHA
[R32 type]
Specifications
Ivory (3.0Y 7.8/1.1)
Color (Munsell)
Exterior
Material Air outlet grille: PP resin
Weight 1.2kg
Air outlet direction
Changeable between up, down or sideways
Accessory name x Qty.
Washer faced screw (M5x35) x 4 (Iron
<Material/Surface treatment>
wire (SWCH18A)/Zinc nickel plated)
571.4
PUHZ-ZRP60,71VHA2
PU-P71,100VHAR3
PU-P71,100YHAR3
only 1 piece required
PUHZ-SHW112VHA
PUHZ-SHW112,140YHA
PU-P125,140YHAR6
2 pieces required
[R410A type]
4-6×8 hole