Sealey VS020.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to instruction
manual
1. SAFETY
Familiarise yourself with the applications and limitations, as well as any potential hazards, of the kit.

Keep this product in good working order and condition. (take immediate action to repair or replace damaged parts).

Use approved parts only (unapproved parts may be dangerous and will invalidate the warranty).

Keep children and unauthorised persons away from the work area.

Keep work area clean and tidy and free from unrelated materials.

Ensure the work area has adequate lighting.

DO NOT use the kit to perform a task for which it is not designed.

DO NOT allow untrained persons to use the kit.

DO NOT use whilst under the influence of drugs, alcohol or intoxicating medication.

After use, clean equipment and store in a cool, dry, childproof area.

Dispose of waste liquids in accordance with local authority regulations.

Always read and comply with the warnings on the brake fluid container.

Wear eye protection and keep skin contact to a minimum. If brake fluid enters eyes, rinse with plenty of water and seek medical

advice. If swallowed seek medical advice immediately.
WARNING! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.

WARNING! Brake fluid will damage paintwork. Any spillage should be flushed with water immediately.

After use, clean equipment and store in a cool, dry, childproof area.

2. INTRODUCTION
Simple, one-man operation using standard workshop air supply (90-120psi). Quick, clean and efficient. Does not require specialised brake
reservoir caps. Draws fluid from the bleed nipple enabling either bleeding or full replacement of fluid in system.
3. SPECIFICATION
Model No: .............................................................. VS020.V2
Maximum Air Supply: .................................................. 120psi
Air Consumption:.................................................... 180ltr/min
Vacuum: ..........................................................................60%
Tank Capacity: .................................................................. 1ltr
Inlet Size: ..................................................................1/4"BSP
fig.3
© Jack Sealey Limited
PNEUMATIC BRAKE BLEEDER
VS020.V2
MODEL NO:
Wear eye
protection
fig.1
fig.4
Original Language Version
fig.2
fig.5
VS020.V2 Issue: 5(HF) - 21/02/18