Go To Ground (Control To Local Ground Pressure) - GE Druck ADTS 405 R Mk2 Instruction Manual

Chapter 3. Getting Started

3.5.4 Go to Ground (Control to Local Ground Pressure)

Dual parameter display
26 | ADTS 405 R/F Mk2 Instruction Manual-English
Single parameter display
Note: In Leak Measure, use F2
and F3 for QFE and QNH
information. F1 is only valid in
Control mode.
Note: This ground value will
not be zero and depends on
local atmospheric pressures
Note: Safe to disconnect
pipes and adaptors from the
aircraft or component under
test.
© 2017 General Electric Company – All Rights Reserved.