Download Print this page

Installation - Pioneer CM Series Installation And Instruction Manual

Surface mount speaker

Advertisement

Introduction
Thank you for purchasing this product. Be sure to read the "Read Before Use" before using this product. Also, read the installation
and user's manual from the support site that can be viewed from the URL or QR code given here. You may require the installation
and user's manual in future, so keep them carefully at a safe location.
http://www.pioneerproaudio.com/en/sound/ceiling/surfacemountspeaker.html
Read Before Use (Important)
[For American Users (Pour les utilisateurs aux États-Unis)]
IMPORTANT NOTICE
THE MODEL NUMBER AND SERIAL NUMBER OF THIS EQUIPMENT ARE ON THE REAR OR BOTTOM.
RECORD THESE NUMBERS ON YOUR ENCLOSED WARRANTY CARD AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE.
[For American Users and Canadian Users]
The Safety of Your Ears is in Your Hands
Get the most out of your equipment by playing it at a safe level – a level that lets the sound come through clearly without annoying blaring or
distortion and, most importantly, without affecting your sensitive hearing. Sound can be deceiving. Over time, your hearing "comfort level" adapts to
higher volumes of sound, so what sounds "normal" can actually be loud and harmful to your hearing. Guard against this by setting your equipment
at a safe level BEFORE your hearing adapts.
ESTABLISH A SAFE LEVEL:
• Set your volume control at a low setting.
• Slowly increase the sound until you can hear it comfortably and clearly, without distortion.
• Once you have established a comfortable sound level, set the dial and leave it there.
BE SURE TO OBSERVE THE FOLLOWING GUIDELINES:
• Do not turn up the volume so high that you can't hear what's around you.
• Use caution or temporarily discontinue use in potentially hazardous situations.
• Do not use headphones while operating a motorized vehicle; the use of headphones may create a traffic hazard and is illegal in many areas.
[For European Users]
If you want to dispose of this product, do not mix it with general household waste. There is a separate collection system for used
electronic products in accordance with legislation that requires proper treatment, recovery and recycling.
Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge
to designated collection facilities or to a retailer (if you purchase a similar new one).
For countries not mentioned above, please contact your local authorities for the correct method of disposal.
By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent
potential negative effects on the environment and human health.

Installation

This loudspeaker should be installed by a professional installer.
There is a risk the loudspeaker may fall. Ask a professional
installer that possesses sufficient skills and experience to install
the loudspeaker. Two or more workers are also recommended for
installation.
AlphaTheta Corporation bears no responsibility for accidents and
damage resulting from deficient installation or mounting, misuse,
modifications, and/or natural disasters.
Only the workers installing the loudspeaker should be near it
during installation.
There is a risk of injury if parts fall.
Tighten the screws and bolts to the indicated torque.
• Falling of screws and bolts may result in injury or accident.
• The knob of the knob screw for the U-bracket is for temporary fixing.
For permanent fixing, use a torque wrench to adjust the torque and
then fix it in place.
2
WARNING
When installing the loudspeaker on the ceiling or a wall, ensure
safe installation by confirming the strength of the installation
location and checking the installation method.
If the installation location or installation means such as installation
fixtures, etc. do not have enough strength to withstand the mass of the
loudspeaker system, it could result in falling of the loudspeaker. Also,
be sure to implement redundant safety measures such as by using the
supplied wires, etc. If the length of the supplied fall prevention wire is
not sufficient, arrange for a wire with appropriate length and strength in
consideration of the speaker weight and installation condition. Secure
the fall prevention wire on the building at a location different from where
the loudspeaker mounting fixture is secured on the building.
Do not install the loudspeaker in the following environments.
• Locations with a large amount of oily smoke and smoke for theatrical
or stage performances.
• Locations that are constantly exposed to water.
• Locations with a large amount of oily smoke, such as inside kitchens
or factories.
• Unstable locations, such as those exposed to vibrations.
• Locations where flammable materials are used, such as alcohols
and aerosol insecticides.
• Locations affected by heat generation, such as near light fixtures or
heaters.
• Locations exposed to direct sunlight.
D36-AP9-1_A1_En
S001a_A1_En
K058b_B_En

Advertisement

loading