Download Print this page

Sealey ProJump PROJ12 Instructions page 2

Advertisement

3. SpecIfIcaTIoN
model no...................................ProJ12...............................ProJ12/24
Voltage.............................................12V..................................12 or 24V
cable section..............................20mm
length...............................................5m...........................................7m
4. operaTIoN
4.1.
Go to donor car engine must be switch off.
4.2.
connect red clamp to positive battery terminal.
4.3.
connect black clamp to negative battery terminal.
4.4.
Green led - functioning correctly go to 4.7
4.5.
red led - Wrong connection - swap clamps over.
4.6.
Amber led - low battery, either run engine until green led stays on or find another donor vehicle go back to 4.1
4.7.
disconnect red positive clamp to switch off test circuit.
4.8.
Go to flat battery vehicle and connect other red clamp to positive and other black clamp to negative.
4.9.
Amber or no led - go to 4.12
4.10.
red led - Wrong connection - swap clamps over.
4.11.
Green led - Battery not at fault - fault with vehicle.
4.12.
reconnect red positive clamp to donor vehicle.
4.13.
correct and safe connection is complete.
4.14.
start flat battery vehicle.
4.15.
if the cables become excessively hot , allow a few minutes for them to cool before trying again.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
ImporTaNT: no liability is accepted for incorrect use of this product.
WarraNTy: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
2 ..................................................
25mm
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
2
01284 757500
01284 703534
ProJ12, ProJ12/24 | issue 3 30/08/16
www.sealey.co.uk
sales@sealey.co.uk

Advertisement

loading

This manual is also suitable for:

Projump proj12/24110-4153110-4257