Peripheral/Option Checks; Input Power; 10-5-3-1Mains Cable Inspection; Cleaning - GE LOGIQ 100 PRO Technical Publication

G HE
E ALTHCARE
D 5305880-100, R
IRECTION
10-5-2-2

Peripheral/Option Checks

If any peripherals or options are not part of the system configuration, the check can be omitted.
Refer to the User Manual for a list of approved peripherals/options.
Step Item
1 VCR
VGP
2
Printer
B/W
3
Printer
4 Footswitch
Table 10-8 GE Approved Peripheral/Hardware Option Functional Checks
10-5-3

Input Power

10-5-3-1 Mains Cable Inspection
Step Item
Unplug
1
Cord
2 Inspect
3 Verify
4 Verify
Table 10-9 Mains Cable Inspection
10-5-4

Cleaning

10-5-4-1 General Cleaning
Step Item
1 Console
Probe
2
Holder
Table 10-10 General Cleaning
Ap p r o v e d Do c u m e n t - 5 3 0 5 8 8 0 - 1 0 0 T PH_ r 3 . p d f Pa g e 1 8 0 o f 1 9 7
3
EVISION
Verify record/playback capabilities of the VCR. Clean heads and covers if necessary.
Verify hardcopy output of the video graphic printer. Clean heads and covers if necessary.
Verify hardcopy output of the B/W printer. Clean heads and covers if necessary.
Verify that the footswitch is functioning as programed. Clean as necessary.
Disconnect the mains cable from the wall and system.
Inspect it and its connectors for damage of any kinds.
Verify that the LINE, NEUTRAL and GROUND wires are properly attached to the terminals, and that no
strands may cause a short circuit.
Inlet connector retainer is functional.
Use a fluid detergent in warm water on a soft, damp cloth to carefully wipe the entire system. Be careful
not to get the cloth too wet so that moisture does not enter the console.
Clean probe holders. (they may need to be soaked to remove excess gel).
Chapter 10 - Quality Assurance
LOGIQ™ 100 PRO S
Description
Description
Description
M
ERVICE ANUAL
Page 10-9