Framework
IN
NO
C
G
A
B
RX
TX
G
NA
RESET
HD-SDI
Side Panel
6
Yellow light
Reserved port
I/O port
GND
RS485 port
Reserved port
RESET button
GND
Please refer to the following interface for side panel dimension information.
•
Software indication light. It is on after
the software loaded successfully.
N/A
Alarm input ground end.
RS485_A port.
It is to control the 485 tool to set the video
parameter.
RS485_B port.
It is to control the 485 tool to set the video
parameter.
N/A
•
Restore factory default setup.
•
When system is running normally
(power indication light is red), press
the RESET button for at least 5
seconds, system can restore factory
default setup. Yellow light flickers.
Send out the SDI video stream conforming
to the HD-SDI specifications.
Please make sure the device is securely
earthed to prevent the thunderstorm strike.