Advertisement
4. battery installation
4.1.
Turn unit over to expose back. Press in the plastic tab on the right middle of the back cover and lift up to open.
4.2.
Use a Philips screwdriver to remove the screw in bottom middle of the battery cover.
4.3.
Remove cover and insert 4AA batteries as shown inside the compartment.
4.4.
replace screw.
fig.2
5. operation
This Borescope inspection camera unit comes fully assembled. Before first use, carefully peel off the plastic label over the LCD.
5.1.
To begin use, carefully uncoil the camera probe assembly coiled around the battery compartment.
5.2.
Once probe is fully extended, align the cable with the opening on the upper right of the backside of the unit.
5.3.
Align and replace the cover inserting the left hand tabs into the housing first.
5.4.
Press down to ensure a good fit, making sure the cable fits through the opening.
5.5.
Turn unit over, press and hold the power button for 3 seconds to turn on.
5.6.
Point the camera-tipped end of the probe at the target, feed the probe through any holes or bend the probe around objects if necessary.
5.7.
do not forcefully bend, kink, or pull the probe, this will damage it.
5.8.
Use the function buttons as described in fig.1 to set light output, screen size, zoom and viewing orientation.
5.9.
Press and hold power button again for 3 seconds to turn off.
6. maintenance
6.1.
Make sure the screws are properly tightened to be able to work safely. Use only original accessories and original spare parts.
6.2.
If the device is not used, it should be stored in a dry place, away from children.
6.3.
If the cable is damaged, replace it with another one which has the same characteristics. Entrust this operation to a qualified technician or
a repair shop.
6.4.
All defects should be repaired by a service workshop authorized by the manufacturer.
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
battery removal
See section 4.
under the Waste Batteries and Accumulators regulations 2009, Jack sealey ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's
registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: No liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
fig.3
Advertisement
