Sealey VS0563 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE, FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO
MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
1. SAFETY INSTRUCTIONS
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when

using tools and equipment.
DO NOT use gauge if damaged.

Maintain gauge in good and clean condition for best performance.

Keep the work area clean, uncluttered and ensure there is adequate lighting.

Keep children and unauthorised persons away from the work area.

DO NOT use the gauge for any purpose other than for which it is designed.

DO NOT get gauge wet or use in damp or wet locations, or areas where there is condensation. Keep gauge clean and dry

using a dry cotton cloth only.
DO NOT dip or submerge the gauge in any type of liquid.

DO NOT expose gauge to bright sunlight or dust.

DO NOT dis-assemble gauge. The gauge must be checked by qualified service personnel only.

DO NOT apply any voltage to the gauge i.e. with an electric marker pen.

The gauge is a precision instrument, treat with care, avoid using force and do not subject to knocks or shocks.

Use gauge in reasonably constant temperature conditions of approximately 20°C.

When not in use, turn off and store gauge in a safe, dry, childproof location.

2. INTRODUCTION & SPECIFICATION
Calibrated and VOSA approved for use when MOT testing all classes of vehicle.
Hardened and tempered stainless steel gauge. 7mm High figures in LCD display
for ease of reading. Metric and Imperial calibration with conversion between the
two. Zero setting control allows for comparative measurement. Supplied with
zero set bar.
Specification ...................................................................................... Depth Gauge
Resolution......................................................................................0.01mm/0.0005"
Range ............................................................................................... 0-10mm/0.04"
Accuracy ......................................................................................±0.01mm/0.0005"
Battery type ........................................................................................CR2032 (3V)
Operating temp. ..................................................................................... 0°C - 40°C
Storage temp. ..................................................................................... -10°C - 60°C
fig.1
© Jack Sealey Limited
INSTRUCTIONS FOR:
DIGITAL TYRE DEPTH GAUGE -
VOSA APPROVED
MODEL NO:
Original Language Version
VS0563
Figure 1
Item Description
1
2
3
4
5
6
7
8
9
10
11
VS0563
Depth measuring probe
LCD Display
mm/inch Button
Locking screw
Base
Power "ON/OFF" button
Zero set button
Battery cover
Beam
Zero set bar
Battery
ISSUE No:3(I) 30/01/15