Sealey AP0618 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: pleAse reAd these instructions cAreFullY. note the sAFe operAtionAl reQuirements, wArninGs & cAutions.
use the product correctlY And with cAre For the purpose For which it is intended. FAilure to do so mAY cAuse
dAmAGe And/or personAl inJurY And will inVAlidAte the wArrAntY. pleAse keep instructions sAFe For Future use.
1. sAFetY instructions
1.1. GenerAl sAFetY
wArninG! Ensure Health & safety, local authority, and general workshop practice regulations are adhered to when

using this workbench.
Locate workbench in a suitable work area.

Keep the work area clean, uncluttered and ensure there is adequate lighting.

wArninG! use workbench on level and solid ground, preferably concrete.

Keep the workbench clean and tidy in accordance with good workshop practice.

Keep children and unauthorised persons away from the work area.

do not use the workbench for any purpose other than that for which it is designed.

do not use the workbench outdoors.

do not place the workbench in a damp or wet location or an area where there is condensation.

do not clean the workbench with any solvents which may damage the surfaces or the protective coating.

 do not move the workbench when there are items placed on it.
 do not overload the workbench.
 do not undertake work on the workbench without the workpiece being adequately secured. use clamps or a vice (not
included) to secure the workpiece (available from your sealey dealer).
wArninG! the warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions

and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2. introduction
25mm thick wood top, used for added extra rigidity and durability. Powder coated steel frame, for added corrosion resistance.
four adjustable feet for levelling on uneven ground.
dimensions: Width: 1805mm, Depth: 605mm, Height: 910mm. Maximum capacity: 500kg - evenly distributed.
3. contents
unpack the contents and check against the parts list. If there are any parts missing, contact your sealey dealer.
part no. part name
1 table top
2 H Leg frame
3 Horizontal Brace
4 M8 x 70mm Pan Head Hex Bolt
© Jack sealey Limited
no. of
1
2
1
12
Original Language Version
InstructIons for:
workbench 1.8mtr steel with
25mm rubberwood top
Ap0618
:
MoDEL no
AP0618 Issue: 1 - 19/09/12