Advertisement
Check Indicator Status
Observe indicators on each AC and
information immediately and take measures based on the meaning of the indicator state described in the
Product Description
of the product. If the fault cannot be rectified, contact your agent or Huawei
enterprise technical service hotline.
The following table lists the normal indicator states on an AC and an AP.
Category
Indicator
AC
PWR
SYS
STAT
SPED
PoE
Service
indicator
SYS
AP
Link/ACT
Wireless
If all indicators on an AP are off, the indicators may have been turned off using
the led off command. It is recommended that you run the undo led off command
on the AC to turn on the indicators and then check indicator status again.
AP. If you find any indicator in an abnormal state, record the fault
Normal State
Steady green (If there are two indicators, at least one of them should be
steady green.)
Slow blinking green
Steady green
Off
Off (Ignore this if there is no PoE indicator on the AC.)
Network cable connected: steady green
port
No cable connected: off
Slow blinking green
Steady green or blinking (Ignore this if there is no Link/ACT indicator on
the AP.)
Blinking yellow or green or steady on (Ignore this if there is no Wireless
indicator on the AP.)
3
Advertisement
