Bar-Amp Board Block; Bar-Amp Board - Sony HT-MT500 Service Manual

2-12. BAR-AMP BOARD BLOCK

FFC 26P
front side
4 screw
(BVTP3
8 BAR-AMP board block
6 Move the cable
to the side.
6 Move the FFC
to the side.

2-13. BAR-AMP BOARD

2 AMP heatsink
Note 1: When installing the AMP heatsink,
align the two bosses and two holes.
Note 2: When installing the AMP heatsink,
spread the compound referring to
"SPREADING OF COMPOUND"
on page 8.
CN6013
The opposite side
is terminal side.
4 screw
(BVTP3 8)
5 wiring stopper
8)
hole
hole
1 two screws
(BVTP3 10)
boss
boss
hole
hole
rib
4 AMP chassis block
bottom panel block
left side
3 FFC 26P
(CN6013)
7 Draw the jack and connector
out of the three holes in bottom
panel block.
4 screw
4 screw
(BVTP3
5 wiring stopper
6 Move the cable
to the side.
hole
3 screw
(BVTP3 8)
5 BAR-AMP board
hole
hole
rib
HT-MT500/MT501
2 MB-1610 board cable
connector (CN6015)
1 MB-1610 board cable
connector (CN6014)
front side
(BVTP3 8)
8)
Note 3: When installing the BAR-AMP board,
align the two ribs and two holes.
Note 4: When installing the BAR-AMP board,
refer to "BOND FIXED POSITION OF
ELECTRICAL PARTS" on page 8.
right side
19