Kenwood TKR-851 Service Manual page 27

Uhf fm repeater
Hide thumbs Also See for TKR-851:
Table of Contents

Advertisement

Item
Condition
33. Repeat
1) CH : 2
gain level
SSG output : –53dBm
(Wide)
SSG MOD : 1kHz
SSG DEV : 1kHz
Deviation meter filter
HPF : OFF
LPF : 15kHz
De-emphasis : OFF
Transmission
(Wide 4kHz) 2) CH : 2
Transmission
(Narrow)
3) CH : 2
Transmission
When "RF Power Down Detect" is programmed in the AUXO function, threshold of transmission output is set with the following nemu.
34. Power
1) CH : 2 (High power)
down detect
(High)
(Low)
2) CH : 2 (Low power)
Confirmation and Alignment of Set-up to
Prevent Receiver Desensitization
1.Confirmation of Duplexer alignment
The duplexer allows the Repeater to simultaneously trans-
mit and receive. To accomplish this, in the programmed re-
ceive frequency, the transmit frequency must be notched or
suppressed by 75dB or more. Additionally, on the pro-
grammed transmit frequency, the receive frequency must be
notched or suppressed by 75dB or more. The following fig-
ures are examples of Duplexer alignment using a spectrum
analyzer.
Ref –10dBm
Atten 5dB
# Peak
Log
10dB/
V1 V2
V3 FC
AA
TX
VBW 30kHz
#Res BW 30kHz
ADJUSTMENT
Measurement
Test-
Unit
equipment
SSG
Rear
MOD ANA
or
Deviation
meter
Oscilloscope
Power meter Rear
RX
Span 20MHz
Sweep 50ms (401 pts)
Adjustment
Terminal
Unit
Parts
RX ANT
PC adj.
1kHz
TX ANT
TX ANT
PC adj.
10.0W
(Factory-default)
PC adj.
0.4W
(Factory-default)
2.Confirmation of Repeater Desensitization
The following figure is a Test set-up for Repeater Desensi-
tization.
After this Test set-up is completed, confirm the Repeater
Desensitization as mentioned below.
1) Disable the repeater mode.
2) Adjust the level of the RF generator until 12dB SINAD is
reached.
3) Increase the output of the RF generator by 1dB. (This in-
creases the SINAD.)
4) Enable the repeater mode.
5) Read the SINAD level. It should not drop below 12dB
SINAD. If the SINAD is less then 12dB, check the tight-
ness of the connectors and the tuning of duplexer.
Duplexer
Repeater
TKR-851
Specifications/Remarks
Method
± 0.1kHz
Attenuated
port
50Ω
dummy
RF signal
generator
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

B51-8684-00B51-8701-00B51-8709-00

Table of Contents