Advertisement
Available languages
Available languages
Adjusting Make-Up Air Module Fan Speeds/Airflow
ADJUSTING MAKE-UP AIR MODULE FAN SPEEDS/AIRFLOW
1. After installing the filter, the Zoneline into the wall
sleeve, and re-energizing, the airflow of the make-up
air module can be adjusted through the Aux settings.
2. With the front panel of the Zoneline off, press the red
AUX SET button located behind the room cabinet,
below the user interface.
Make-up Air Module Filter Airflow Information
Data below is when module is equipped with the RAA13
1" MERV13 filter at 0.0 in. H
Make-up Air Module Fan
Speed Setting
(Aux 0_)
6
5
4
3
2
1
See supplementary airflow graph on increasing airflow rates
Air Filter Max Allowable Clean Filter Pressure Drop: 0.1 in. H
Installation Instructions:
Red AUX Set
Button
O static pressure
2
Design Airflow Rate (cfm)
28
25
21
18
15
12
0
2
3. "AU" appears on the display. Press the MODE button
on the user interface until a double numerical digit
starting with "0" shows up (should be either 00, 01,
02, 03, 04, 05, 06).
4. Using the "Supplementary Airflow" graph below,
choose a speed setting by pressing the up (+) or
down (-) buttons to select one of the settings; 00-06.
5. Press the red AUX SET button again to save the
selection, which will cause the make-up air module to
reset and go through its startup procedure.
6. Replace the front cover of the Zoneline.
Supplementary Air ow - RAA13 Air Filter
Make-up Air Module Fan Speed Se ng (Aux 0_)
Volumetric Flow Rate (CFM)
0
5
10
15
0
-0.02
-0.04
-0.06
-0.08
-0.1
1
2
2
20
25
30
35
40
3
4
5
45
50
6
Advertisement
